I have found a good site with a lot of sound proofing advice and products. I like their "best" solution but one section is confusing. I have made a convenient screen cap that you can look at or you can visit the site here: https://www.soundproofcow.com/existing-wall-soundproofing-assemblies/This part is unclear: are they actually saying that you leave a 1/4 inch gap everywhere, including between the panel and the existing wall, and you fill that entire area with sound sealant, which makes sense acoustically but would be very difficult. Or, are they just referring to the gaps around the edges of the panels where they butt up against the existing wall or an adjacent panel. I live near a lot of mexicans; if you are familiar with their culture you understand the need for sound abatement. Imagine this shit at 3 am (turn it up as loud as your speakers can handle - I think that's a rule): https://www.youtube.com/watch?v=C3lW8zAHwSE
The gap between the gypsum board and wall is filled with a soundproof mat. The 1/4 gap filled with caulk is all around the soundproof barrier boards>Leave a ΒΌ inch gap between the new layer of gypsum board and all adjoining wall, ceiling and floor surfaces.
>>2787555thx 555 anon. that makes sense.
>>2787547Here before you buy anything watch a couple videos by this guy instead. https://www.youtube.com/watch?v=UHKK2jkClcAHe references actual professional soundproofing literature with quantifiable measurements and isn't financially motivated to shill a particular brand of soundproofing materialSummary: more mass good, material phase transitions good, acoustic bridging bad, cheap DIY possible and effectivetl;dr: air gap > fiberglass insulation > stud > isotrac > 5/8ths drywall > pressure sensitive carpet adhesive (or green glue or mass loaded vinyl for the same effect but more $$) > 5/8ths drywallBut even if you do all that the sound is gonna come through your windows anyway unless you build a plug for them
>>2787589>unless you build a plug for themthx for the video; I'll watch it later. The nice thing about the room is I boarded up the windows years ago because they were the old roll-out kind that never seal and were facing neighbors so the curtains were always drawn. So I stuffed them full of fiberglas insulation then a sheet of 1/2" plywood.My initial idea was to haul in cinder blocks and make walls with the blocks filled with concrete, but that's so impractical and apparently not that great at sound abatement anyway, or at least that's what the site in OP says.
>>2787547bro, i get you...first, the "best" solution you're referring to is indeed the best, you want to have an original massive wall (plug all holes as much as you can) then space (this is *really* beneficial, but decreases your room space) then a soft barrier (also thick as you can spare) then 2 or 3 layers of the heaviest plasterboard you can bring in. this will make tremendous effect.the problem is the way the sound transfers, you must be extra careful with the installation and follow all the recommendations to avoid sound leaking. even then the sound will resonate through other walls and the floor. if you cover all the other walls/ceiling that leaves the floor which you should insulate too, and hopefully there's no sound coming through the windows.it's an enormous energy and money waste, and it's pretty certain you will miss something and it will make you mad and depressed, but just keep at it, if you don't want/can't move