Bros,How would you paint black or darken the metal frame on pic related?I've tried a couple of methods so far:>Hot bluingNot the results I was expecting. Too light tone and not that scratch resistant.>Epoxy paint (Rust-Oleum Appliance Epoxy)Looks great but not durable at all. The paint just comes off too easily.Is there a primer I should use or special paint/method?I've consider cold bluing, but the liquid is quite expensive. Also some say the piece smells bad after going through this process.
>>2787344Cerakote, prepare your wallet
Use a sharpie
>>2787367Interdasting, expensive and hard to apply. But it could work>>2787386I did that just for testing how it would look like, kek
>>2787344buy one with a black rim. what are those like $20 at walmart?second is 3d print onethird sand and acrylic paint.treating the metal depends on what metal it even is. do you know?
>>2787497There is duracoat too which is air-cure but not quite as durable as cerakote, but it's not like it immediately flakes off or something. Any other methods you are talking about sending in parts for chemical processes. Some jewelers may be able to do some stuff.
>>2787511G shocks are like $100-1000
>>2787511>buy one with a black rimThe one with the black rim is quite expensive, and not available in my country. Besides this is /diy/>3D printcould be, maybe I could do a mold to cast another material>acrylic paintIs that durable?>what metal it even is. do you know?I think it's stainless steel>>2787533>duracoatI remember that lolbertarian nutnfancy shilling duracoat some years ago. I'll look into itWhat happens if I dip it on black expoxy glue?
Is that stainless steel?You might be able to rust it with bleach (or other chemical depending on the grade of stainless), then hot-water treatment to turn it into black magnetite.After that, you also have a good painting/dye surface.I mean dye, as in what they do with anodized aluminum to get the black color,Thin coats and repeat is the key.