[a / b / c / d / e / f / g / gif / h / hr / k / m / o / p / r / s / t / u / v / vg / vm / vmg / vr / vrpg / vst / w / wg] [i / ic] [r9k / s4s / vip / qa] [cm / hm / lgbt / y] [3 / aco / adv / an / bant / biz / cgl / ck / co / diy / fa / fit / gd / hc / his / int / jp / lit / mlp / mu / n / news / out / po / pol / pw / qst / sci / soc / sp / tg / toy / trv / tv / vp / vt / wsg / wsr / x / xs] [Settings] [Search] [Mobile] [Home]
Board
Settings Mobile Home
/diy/ - Do It Yourself


Thread archived.
You cannot reply anymore.




File: warp.jpg (2.92 MB, 4000x3000)
2.92 MB
2.92 MB JPG
Anyone have a resin 3d printer? Why is my print hanging off the build plate?
>>
>>2471153
fyi, there's a dedicated thread for 3d printers. check the index for it.
>>
>>2471162
checking now. ty
>>
because you didn't use sprues
resin printing hates parallel flat surfaces because of the suction force that forms between the flat part of the part and the FEP film

orient the part so there is a corner pointed at the build plate and use sprues
>>
>>2471153
>hanging
it realized its design is so awful that it chose to end itself before it could begin



Delete Post: [File Only] Style:
[Disable Mobile View / Use Desktop Site]

[Enable Mobile View / Use Mobile Site]

All trademarks and copyrights on this page are owned by their respective parties. Images uploaded are the responsibility of the Poster. Comments are owned by the Poster.